Caliber RCD 80I Installation Guide download pdf (Page 17)

RCD 272BTi manual

SPECIFICATION

General

Power supply:

12V DC (11V-16V)

Test voltage 14.4V, negative

ground

Maximum power output: 75Wx4 channels

Continuous power output: 20Wx4 channels (4

,10% T.H.D.)

Suitable speaker impedance: 4-8 ohm

Pre-Amp output voltage:

2.0V (CD play mode: 1KHz, 0 dB, 10 K

load)

Fuse: 15A

Dimensions(WxHxD): 178x50x166mm

Weight: 1.7kg

Aux-in: ≥300mV

FM Stereo Radio

Frequency range: 87.5-108.0MHz

Usable sensitivity: 8 dBμ

Quieting sensitivity(S/N=50dB): 12 dBμ

Frequency response: 30Hz-15kHz

Stereo separation: 30dB (1kHz)

Image response ratio: 50dB

IF response ratio: 70dB

Signal/noise ratio: 55dB

AM(MW) Radio

Frequency range: 522-1620 KHz

Usable sensitivity(S/N=20dB): 30 dBμ

Note: Specications and the design are subject to change without notice

due to improvements in technology.

Disc Player

System: Disc digital audio system

Frequency response: 20Hz-20kHz

Signal/noise ratio: >80 dB

Total harmonic distortion: Less than 0.20% (1kHz)

Wow and utter: Below measurable limits

Channel separation: >55 dB

Components

Mounting collar 1

Machine screws M5x6mm 4

Mounting bolt (50mm) 1

L-key 2

Operating instructions 1

Rubber cushion 1

“Made for iPod,” and “Made for iPhone” mean that an electronic

accessory has been designed to connect specifically to iPod, or

iPhone, respectively, and has been certied by the developer to meet

Apple performance standards.

Apple is not responsible for the operation of this device or its

compliance with safety and regulatory standards. Please note that the

use of this accessory with iPod or iPhone may

affect wireless performance.

iPhone and iPod are trademarks of Apple Inc.,

registered in the U.S. and other countries.

1 2 ... 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Caliber RCD 80I Installation Guide Page 17

Comments to this Manuals

Related products and manuals for Car media receivers Caliber RCD 80I